Bovine Obstetrics

BASIC BOVINE OBSTETRICS LABORATORY
'Alveros' Lab

Goals

  • To instruct students how to perform basic manipulations in large animal obstetrics.
  • To instruct students how to perform basic fetotomy cuts.

pp309-323

Click below to view Dr. Ronnie Elmore's KSU images of bovine obstetrics.

Click above to go to a Colorado State Web Page on calving.

The normal delivery is made longitudinal, in the anterior presentation, dorsal sacral position, with bilateral foreleg extension (in other words the calf dives out right-side-up, head and front feet first).

 

 

 

 

 

The white outline in all subsequent photos represents the uterus.
The 'open' end is the birth canal.

The first step in obstetrics is to make sure the cow is restrained in a safe place for both her and you. Make sure that if she goes into recumbence, that she can breathe! It always best to tie the tail out of the way and then wash the vulva (and yourself) before proceeding on with the examination. Always use plenty of lubrication to make things easier for you, the cow and the calf. Trying to do things without proper lubrication can make the extraction much more difficult and tire you out quickly. Commercial lubricants work well, as does ivory liquid, but soaps can wash away the normal lubricants provided by the amniotic and chorioallantoic fluids. It is often helpful to pass a large bore tube into the use and then use a stomach pump to pump 2 to 3 gallons of lubricant into the uterus and around the fetus.

    

Preparation

If both front legs and the head are in the correct position, then you must decide if the calf can pass through the birth canal. Do this by placing obstetrical chains on the forelegs (assuming they are forelegs from the same calf..... more about that later), one loop over the fetlocks and a second half hitch below the fetlocks. Ideally the chains should come over the top of the fetlocks, not the sides or bottoms. You may need to use three point traction by placing a head snare behind the calf's head and in the mouth (the same thing can be done with an OB chain). With 2 or 3 people (no fetal extractors or John Deere tractors) pulling, if  the fetlocks can be presented a hand's width past the lips of the vulva, then the calf should come. Remember to rotate the calf about 450 when pulling so the calf is passing through the birth canal at the maximum diameter of the canal (the canal is oval, not round).

Position

Anterior - 2 point traction

Anterior - 3 point traction

 

The same type of criterion can be used if the calf is coming backwards (yes, it is OK to pull a calf backwards, as long as it is right side up). If the hocks can be presented outside the vulva with 2 or 3 people pulling, then the calf should come out. It is acceptable to use fetal extractors (calf pullers) if this criterion is followed. If you do not follow these pull-no pull criteria then you will try to pull calves that are too large to fit through the birth canal and end up killing dam and calf.

 

 

 

 

If only feet are presented, then you must decide if they are front or back feet....a seemingly idiotic procedure that is oh.... oh. ...oh so important. Front feet have 4 joints that flex in the same direction (coffin, pastern, fetlock, and carp us) before the elbow goes the opposite direction. The back leg has only 3 joints that flex in the same direction (coffin, pastern, fetlock) before the hock goes in the other direction. This seemingly academic procedure can save you much agony and embarrassment. If the legs are back legs, then pull using the pull-no pull criterion. The tail head may have to be pushed down in order to not engage and stop the delivery. If the legs are front legs, make sure they are from the same calf by tracing them back to the same body. Now you have to find the head.

A lateral head deviation is the most common head postural problem. You can sometimes get the head out by placing your hand under the jaw and pulling (never put your hand inside the mouth as the teeth are very sharp and will cut your hand). The second best way is to put your thumb and forefinger it the eye sockets and pull. To successfully do any OB procedure it is imperative that you repel the calf in order to give yourself more room to carry out your mutations. Repelling the calf while you do manipulations is an extremely important aspect of obstetrics that cannot be overemphasized. If you cannot get the head out manually while repelling, you may have to use eye hooks. Place the hook in the medial canthus of the far eye, repel the calf and pull on the head. Alternatively, a 'chain bridle' can be placed around the calf's head to pull it straight.

 

 

 

 

 

 

 

 

 

                

Lateral head deviation

If only one or no front feet are presented then the legs and head must be extended before fetal extraction. If front feet are to be extended, it is done in 2 steps. First grasp the leg between the carpus and elbow and pull, next slide down the leg and grasp it below the fetlock and pull. The same technique can be done using chains to increase your force. Remember to repel when performing mutations!

 

 

 

 

 

Anterior Presentation

 

If only the tail is presented, you have a breech presentation. You must cup one hand under the foot (it will scrape the 'wrong way' against the uterus) and push the hock medially and dorsally while pulling on the cupped foot. You can also do this procedure with chains.

Posterior Presentation

If the calf is upside down, then it must be rotated right side up before extracting. You may be able to do this manually by rocking the fetus, but this is difficult. A detortsion bar makes it much easier. Place a loop on one leg (front or back, whichever is presented) and slide the chain up as far possible (above the elbows). Next, place a loop through the hole on the end of the rod and place that loop over the other leg, again moving it as high up on the leg as possible. Wrap the chain in the direction you want to turn the calf, secure the chain in the other hole and rotate. Remember to lubricate the fetus well, or you can create a uterine torsion (something that you can also use the distortion rod to do if you are trying to correct a uterine torsion).

                                                                     

 

 

 

 

Detorsion

The most complicated, fetal extraction is that of the 'sitting dog' position. This is when all four feet and the head of the calf are presented in the birth canal. It is usually not possible to disengage the rear legs from the birth canal....no matter how hard you try. To correct this condition, place chains on the rear legs and repel the front of the calf back into the uterus. In doing this you will create a posterior presentation in the dorso-pelvic position (backwards and upside down). You now simply use the distortion rod to turn the calf right side up and pull the calf in the posterior presentation.   

'Sitting Dog'

IFetotomy

If you cannot extract the fetus per vaginum you can do a caesarian section or a percutaneous fetotomy. A C-section is the only way to go if the calf is alive, fresh or very large. A fetotomy is the way to go if the calf is rotten, dead, or you expect you can get it out with 1 or 2 cuts. Always decide soon, not when you are exhausted, that you need to do a fetotomy or c-section. The basic rules of fetotomy, always cut off as much as you can with each cut and never leave a sharp end. Cutting off a lateral head deviation is very easy and much faster that a c-section. Always use a two barreled fetotome, not a mouth speculum.

Lateral head deviation fetotomy

 

 Thread the wire through one tube, use a wire passer to pass the free wire end around the head, thread the other side of the tube and cut. Make sure there are not kinks in the wire and that the wires are not crossed while cutting. While cutting, grasp the head of the fetotome firmly with one hand and hold it in position while the other person cuts. Have them start with fast, short strokes and then move to long smooth strokes. Do not let them stop once thy have started cutting or there is a good chance that the wire will break when they start up again. The head usually comes off smoothly because the wire works its way between the vertebrae. When cutting off a front leg, make sure the head of the fetotome is as far past the shoulder and on the opposite side as the leg you are cutting off. This will ensure that the entire shoulder blade is removed. You should also secure the fetotome  with a chain to the leg you are cutting, as well as holding the head of the fetotome in place. If the shoulder blade is left you have accomplished nothing as far as reducing the diameter of the calf.

Front Leg Fetotomy

When cutting off a back leg, again position the head of the fetotome far in past the pelvis of the calf and on the opposite side as the leg you are cutting off. Pass the wire between the tail and pin bone on the opposite side as the leg you want to cut off. This will almost guarantee a cut through the hip joint.

Rear Leg Fetotomy

These are the basics of obstetrics. Many variations and infinite situations will arise for you to use your professional judgment to solve the problem in an expedient and economical manner.

.

 


contributed by Bruce E Eilts on 1 November 2007 


contributed by Bruce E Eilts on 25 September 2012




 

To  Main


 

mailto:beilts@lsu.edu

Send an email to ask a question that has not been adequately covered.